I miniaturized the Analog Devices CN0359 evaluation board for a new project, using the ADUCM360BCPZ128. The design was a copy of the evaluation board minus the LCD, buzzer, and Potentiometer selector. I attempted to power the device up yesterday and load the code that I have working on the CN0359 evaluation board. The evaluation board is programmed using JTAG and IAR Embedded Workbench. For the new design I wanted to check if there was anything special I had to do before programming the chip for the first time. When I go to program I keep getting the error, "Failed to get the CPU Status after 4 retries". I am reviewing my design vs the evaluation design files again this morning, but thought I would check in here before getting too far.