EVAL-ADAU196XAZ out-of-the-box experience

I am currently trying to figure out how to use the EVAL-ADAU196XAZ out-of-the-box.

I found that there is an unpublished document for the Rev. B version of the eval board.

/cfs-file/__key/communityserver-discussions-components-files/326/UG_2D00_564_2800_RevA-and-RevC_2900_Preliminary.pdf

I have some questions to get started:

1. The document mentions about the ON/OFF position of the RED switches. May I ask which side is the ON/OFF for these switches: i.e. S2, S5, S6, S9, S7, S10
   1.  
   2. For example: 
      • 
      •  
2. How do I configure the switches for a microcontroller as an external source for MCLK, BCLK,  LRCLK for TDM16 with TDM16 data going in to DSDATA1 only?
3. How do I configure the I2C address on the ADAU1966A for the microcontroller to set the registers? Is it necessary when I run on Standalone mode?
4. I am able to use the adapter board for the eval board to use the ARWB 3.2.1 and SigmaStudio 4.7. Does it override the configuration for the ADAU1966A registers set by the microcontroller?