SSM6515

Hi shanyx,

I've attached a working SigmaStudio project that contains all the necessary register writes to help fix your issue

SS_Basic_Setup.dspproj

I noticed a couple key takeaways from reading your register settings that may help you in the future:

1. RESET = 0x10 means that the board is in a Full Reset state. This register needs to be 0x00. Not sure if these bits were toggled by a register setting script, but these bits should remain 0x00 if you want to output signal from the amplifier.

2. DAC_VOL = 0x03 means that you were setting the volume to have an additional 22.875dB gain. If this was intentional, you can disregard this comment, but if not, this should at least be set to 0x40 to yield a 0dB gain if you are not seeing output from the amplifier to avoid clipping while troubleshooting I/O.

3. Your BCLK rate should always be an integer multiple of your LRCLK rate to have a valid PCM format. With your LRCLK = 48kHz, and assuming you want I2S with 32-bit Slot Width with 24-bit data, using a 2CH setup yields a 3.072MHz BCLK rate or using a 4CH setup yields a 6.144MHz BCLK rate. (Number of Channels x LRCLK Rate x Slot Width = BCLK Rate).

I made some assumptions in the SigmaStudio project that you desired 32 BCLK's per slot with 24-bit data along with an LRCLK rate of 48kHz, but was unsure if you were using 2 Channels or 4 Channels based on your oscilloscope readings of your BLCK at 6.173MHz. 

If that is not correct, I'd be happy to make some further adjustments to your setup and help clear up any further issues.

Hope the project helps clear up the issues you were experiencing!

Best,

TM

Hi shanyx,

I've attached a working SigmaStudio project that contains all the necessary register writes to help fix your issue

SS_Basic_Setup.dspproj

I noticed a couple key takeaways from reading your register settings that may help you in the future:

1. RESET = 0x10 means that the board is in a Full Reset state. This register needs to be 0x00. Not sure if these bits were toggled by a register setting script, but these bits should remain 0x00 if you want to output signal from the amplifier.

2. DAC_VOL = 0x03 means that you were setting the volume to have an additional 22.875dB gain. If this was intentional, you can disregard this comment, but if not, this should at least be set to 0x40 to yield a 0dB gain if you are not seeing output from the amplifier to avoid clipping while troubleshooting I/O.

3. Your BCLK rate should always be an integer multiple of your LRCLK rate to have a valid PCM format. With your LRCLK = 48kHz, and assuming you want I2S with 32-bit Slot Width with 24-bit data, using a 2CH setup yields a 3.072MHz BCLK rate or using a 4CH setup yields a 6.144MHz BCLK rate. (Number of Channels x LRCLK Rate x Slot Width = BCLK Rate).

I made some assumptions in the SigmaStudio project that you desired 32 BCLK's per slot with 24-bit data along with an LRCLK rate of 48kHz, but was unsure if you were using 2 Channels or 4 Channels based on your oscilloscope readings of your BLCK at 6.173MHz. 

If that is not correct, I'd be happy to make some further adjustments to your setup and help clear up any further issues.

Hope the project helps clear up the issues you were experiencing!

Best,

TM