SSM3302 input pin

Question

Hi, Support Team 
 
 Regarding SSM3302, I have the following questions, and could you give me some advice? 
 When using in Mono mode, is there any recommended process for INR+/INR-, such as Open or GND connection? 
 
 Best Regards, 
 NEK

DaveThib · Accepted Answer

Hello NEK, 
 
 Thank you ron.p for moving this over to here. 
 
 The ADC input pins are floating up at a common mode voltage so it is not recommended to ground them. You can leave them floating but I usually do not like doing that because RFI can come into the part via these floating pins. 
 So ground them through a capacitor. You can short the two pins together and use one cap to ground. 100nf is fine. You could also use two 100nf caps to ground if you like, one for each pin. 
 
 Dave T

Electronic Design Services - PartnerZone

SSM3302 input pin

Top Replies