Post Go back to editing

Simple Router not in toolbox in SigmaStudio both 3.11 & 3.12

Hi,

I cannot find the simple router tools in the toolbox in either of the installed versions of SigmaStudio.

I am trying to build a mix matrix like this

https://wiki.analog.com/resources/tools-software/sigmastudio/toolbox/mixerssplitters/audiosignalrouterindexselectable

Am I supposed to use NxM Mixer ( non-linear ) ?

I've made an 8x8 box with NxM mixer but it looks bar bones ! where is the I2C controls for this so I can control the matrix from my

MC ?

sorry I am new to SigmaStudio so this is probably a very stupid question.. unless flexible routing is not possible with the AD1941 dsp IC ?

I'm running windows 8 64bit and both versions of the software installed without error.

any clue would be much welcomed

BEN

Parents
  • OK, I think I can answer this myslef ... I tried loading the ADAU1446 into SigmStudio ( I know this IC supports audio routing after reading more datasheets ) then routing becomes available in the toolbox.

    Makes sence that the lass powerful AD1940 just does do flexible mix routing , although you can fix a route from any source to any output.. perhaps its just that you cannot change them after the IC boots.

    who , knows maybe that helps someone with the same question one day

Reply
  • OK, I think I can answer this myslef ... I tried loading the ADAU1446 into SigmStudio ( I know this IC supports audio routing after reading more datasheets ) then routing becomes available in the toolbox.

    Makes sence that the lass powerful AD1940 just does do flexible mix routing , although you can fix a route from any source to any output.. perhaps its just that you cannot change them after the IC boots.

    who , knows maybe that helps someone with the same question one day

Children
No Data

Before You Switch


Switching languages will make ADI Explorer unavailable. Resume your session by switching back to English and reopening ADI Explorer.