Post Go back to editing

ADAU1962A routing to different output (ADSP-SC573)

Hi,

I would like to ask how can I change routing on ADAU1962A. I trying to rework example for Playback from SPDIF, by default audio is routed on Out0 of ADAU1962A unit. I want to rework it to route it to different output port of ADAU1962A but I can't get it work.

Best Regards,

Konrad 

Parents
  • Hello Konrad,

    I am the support person for the ADAU1962A. The DAC channels on this part are not able to be routed to other channels. If you are using TDM then data slot 0 will go to output 0 of the DAC. (output 1 if you start from 1). If you are using I2S then the first serial data port will go to DAC outputs 1 and 2.

    You will have to do the routing inside of the DSP and send it out the appropriate serial port. I am not the support person for this DSP so I do not know how to do that. It is in software where you are routing a particular stream to a particular output.

    Dave T

Reply
  • Hello Konrad,

    I am the support person for the ADAU1962A. The DAC channels on this part are not able to be routed to other channels. If you are using TDM then data slot 0 will go to output 0 of the DAC. (output 1 if you start from 1). If you are using I2S then the first serial data port will go to DAC outputs 1 and 2.

    You will have to do the routing inside of the DSP and send it out the appropriate serial port. I am not the support person for this DSP so I do not know how to do that. It is in software where you are routing a particular stream to a particular output.

    Dave T

Children
No Data