EVAL-ADICUP3029 error message

We've moved this question to the appropriate forum to support you.

More detail from logging console:

Open On-Chip Debugger (Analog Devices CCES 2.10.0 OpenOCD 0.9.0-ge8d0a22) 0.9.0
Licensed under GNU GPL v2
Report bugs to <processor.tools.support@analog.com>
0
Info : select transport "swd"
adapter speed: 1000 kHz
cortex_m reset_config sysresetreq
Info : CMSIS-DAP: SWD Supported
Info : CMSIS-DAP: Interface Initialised (SWD)
Info : CMSIS-DAP: FW Version = 1.0
Info : SWCLK/TCK = 0 SWDIO/TMS = 1 TDI = 0 TDO = 0 nTRST = 0 nRESET = 1
Info : CMSIS-DAP: Interface ready
Info : clock speed 1000 kHz
Info : SWD IDCODE 0x2ba01477
Info : aducm3029.cpu: hardware has 0 breakpoints, 0 watchpoints
Error: not an Analog Devices Cortex-M based part
shutdown command invoked
in procedure 'init'
in procedure 'ocd_bouncer'

memory bus access delay set to 6 tck
adapter speed: 1000 kHz

Hello,

I didn't see this error before, but there are a few things we can try to solve the issue. Try the following procedures:

1. Updating interface file;
2. Erasing memory.

Regards,
Andrei

Hi. Thank you. I updated the board with the interface file and the error went away - 'Error: not an Analog Devices Cortex-M based part'.

Getting further and now have the following error and the Reset and Delay (1s) tickbox is checked in Startup tab in Debug Configurations.

It was tickbox(s) in the Startup tab in Debug Configurations. All good now (so far!).