I have EVAL-ADICUP3029 board. I followed all the instructions from https://wiki.analog.com/resources/eval/user-guides/eval-adicup3029 to configure the switches and connect the board to Win10 computer via USB. The board is never recognized upon connecting to a PC (I tried two different Win10 x64 computers). S2 switch is switched to "USB" and S5 to "Wall/USB". Using Reset didn't help either. Or reconnecting the baord to USB again. Installing mBed windows serial driver from https://developer.mbed.org/handbook/Windows-serial-configuration didn't help.
Problem resolved. Some project options had to be changed. Also, I had to run Flash -> Erase first.
Thank you very much for your prompt reply. It's an out of the box board. Turned out it was a problem in USB cable, probably one of data wires was damaged so the board lights were on but the…