Search FAQs on the left to see if your question has been answered. Click on the dropdown to view all of the documents associated with the product. If you can't find your question, click on Ask a Question

FAQ: ADuCM360 - IAR Embedded Workbench

Q.

Can the IAR Embedded Workbench be used to develop code for the ADuCM360 ?

-----------------------------------------------------------------------

A.

Yes, this no problem. Please find attached the required system-files for installation, a short document to getting started and the files required for a simple 1st Blink project. First of all, after the installation of the IAR Embedded Workbench, the content of the ADuCM360_IAR ZIP-file must be placed in the appropriate installation folders. Than the simple project for the ADuCM360 can be started as explained in the attached document.

Comments
Anonymous
    •  Analog Employees 
    over 8 years ago in reply to MichaelCorwinRonanEng

    Hi,

    You might have accidently selected an ARM7TDMI part in the device selection dialog rather than the ADUCM360.

    •  Analog Employees 
    over 8 years ago in reply to MichaelCorwinRonanEng

    http://ez.analog.com/message/56028#56028 contains further suggestions that I hope help you to progress this issue.

  • I tried using the settings as in the PDF and was unable to match exactly what it had suggested. The first and second pages I was able to match but the third I was not.

     

    My options for Reset on the third page are:

    Hardware, Halt at 0

    Hardware, Halt after delay(ms)

    Hardware, Halt using breakpoint

    Hardware, Halt at 0

    Hardware, Halt using DBGRQ

    Software

     

    I selected “Hardware, Halt at 0” I don't think this matters.


    The Clock section is grayed out so I can not access it and it does not match the PDF. I don’t know if these differences would cause the problem. It shows a 72.0MHz CPU clock

     

    When I try and download and debug I get the same message:

    "Missing or malformed flash loader specification file: C;\Program Files\IAR Systems\Embedded Workbench 6.4 Kickstart\ARM\Config\flashloader\

     

    Do you have any other suggestions?

    •  Analog Employees 
    over 8 years ago in reply to MichaelCorwinRonanEng

    The default ADuCM360_Flash_standalone.icf linker file should work fine.

    Regarding your download issues, I suggest checking my settings as shown on this post:

    http://ez.analog.com/thread/14432

  • I have Downloaded the latest version of the IAR Embedded Workbench V 6.40 and tried to follow the "Getting Started with ADUCM360 MiniKit pdf". I ran into the problem at step 8 - Select the ADuCM360XLINK congif file - ADUCM360.ICF. This file is nowhere to be found on my system so I left the default lile ADUCM360_FLASH_Standalone.ICF. Later on in the proceedure when I try and download and debug I get the message "Missing or malformed flash loader specification fole: C;|program files\IAR Systems\Embedded Workbench 6.4 Kickstart\ARM\config\flashloader\

Related