Q: I would like to use the ADuCM350 to do potentiostat type measurements ?
A: Please refer to AN-1281 and the Amperometric example code in the Software Development Kit. Details in Featured Content on ADuCM350 Engineerzone homepage.
Q: Can I put a +200mV step on sensor ? See AN-1281+ details n Featured Content on ADuCM350 Engineerzone homepage.
A: Yes. At time=0, the system is calibrated so that no voltage across sensor (both sides precisely calibrated to 1.1V).
At time=1, the DAC can output 1.3V to give a DC step across sensor of 200mV.
Q: I have changed RCAL/RTIA on my board, how do I reflect this change in the Amperometric Measurement example from the SDK?
A: Please refer to the following: http://ez.analog.com/docs/DOC-11063