Flash programing  MCU ADuCM3029 and ADuCM360/ADuCM361

I have few question about flash programming Analog Devices Precision Microcontrollers.
First: There is any "factory erase" procedure or something like that for remove protection by SWD in ADuCM360/ADuCM361 microcontrollers?
Second:If i good understand for set read protection I must do it, in code after every reset , not once during flash programming in ADuCM360/ADuCM361 microcontrollers?

Third: I have problem with programing flash memory in ADuCM3029 microcontrloler. I wrote procedure for programing memory, but when i try read flash memory via SWD i lost connection. I noticed that when I try to read the memory after programming, bit FLCC_POR_SEC is set and this is problem, but i dont know why that bit is set. After use mass erase procedure i can again read memory.

Parents
  • 0
    •  Analog Employees 
    on Aug 2, 2018 4:04 PM
    This question has been assumed as answered either offline via email or with a multi-part answer. This question has now been closed out. If you have an inquiry related to this topic please post a new question in the applicable product forum.

    Thank you,
    EZ Admin
Reply
  • 0
    •  Analog Employees 
    on Aug 2, 2018 4:04 PM
    This question has been assumed as answered either offline via email or with a multi-part answer. This question has now been closed out. If you have an inquiry related to this topic please post a new question in the applicable product forum.

    Thank you,
    EZ Admin
Children
No Data