I've recently bought a Eval-ADUCM350EBZ development board and it came with a EV-ADUCM350-BIO3Z-ND ( BIO3Z REV. B) daughter board.
I try to understand how to use this board and has failed to find any document/schematic related to this board.
Can anyone please help?
Thank you very much,
You'll find a document, example code, and schematic about the BIO3Z board on the link below
this FAQ might be able. On this link, there is a file attachment which has instructions on how to use the EKSP.
Can you change to frequency sweep from 1KHz to 25KHz for now? We saw this handshaking error sometimes happen at 30KHz to 40KHz
Thank you very much. It's really useful information.
Another thing, the instruction on the link require using IAR with SDK. I am currently using the EKSP software, due to my very limited knowledge with a embedded platform. Is there any basic guide to show me if I can verify the measurement correctly with the daughter board, even just to measure impedance of a single resistor or so.
Thank you very much for your support.
Thank you very much again for your very prompt support.
I have followed the document " ADuCM350 Evaluation Kit Software Platform" and get to the stage where I can initiate the measurement.
1. When I did a measurement with no BIO3Z board attached, I got the following outcome
This is not match up with what I expected from the document. So I thought I I need to get the BIO3Z attached.
2. When I did attach the BIO3Z daughter board, the software shown " ADuCM350 UART Handshaking Error".
Do you think there is something wrong with the link set up on the daughter board that cause such an error?