This community is available for customers looking for support using the customized ADuCM360 Eclipse based IDE. If there are questions pertaining to the tool chain, plugins, or other elements of the IDE, please post your questions/comments here.
The ADuCM360 Eclipse IDE currently supports the EVAL-ADICUP360 Arduino Compatible Development Board. Details about the IDE, EVAL-ADICUP360, example projects, and connectable hardware can be found at the following web address. EVAL-ADICUP360 User Guide [Analog Devices Wiki]
Unfortunately giugia and yourself have posted a question in response to an introduction document. This document is not monitored by a support engineer. Please post a question in the CM4xx Mixed Signal Control Processors forum to receive a response. Mentioning your specific part number will alert a support engineer.
Hello. Could you let me know if this was resolved, as I have the same issue?
I am running Command Line Interpreter (CLI) demo. After I debug and upload the project to the board (EVAL-ADICUP360 Arduino Compatible Development Board), I have problem in visualizing the “welcome message”. I use a terminal application run at 9600-8-N-1 without flow control as suggested and I set the jumpers according to the different configurations. I tried all the three possible jumper configurations but I did not obtain any results. The terminal do not interpret correctly what it is receiving, so it is impossible to visualize the “welcome message”. I cannot figure out where the problem is. Is there anything else I should do in order to enable the correct serial communication?Thanks in advance!