The Engineering Mind
3D ToF Depth Sensing
Clock and Timing
Design Tools and Calculators
Direct Digital Synthesis (DDS)
Embedded Vision Sensing
Energy Monitoring and Metering
FPGA Reference Designs
Interface and Isolation
Low Power RF Transceivers
MEMS Inertial Sensors
Motor Control Hardware Platforms
Power By Linear
Processors and DSP
RF and Microwave
Wide Band RF Transceivers
Wireless Sensor Networks Reference Library
ARM7 Core Products
ARM7 Core Products requires membership for participation - click to join
ADC inputs on ADuC7060
ADuC7020: Spec marking
ADUC7020_I2C 400KHz ISSUE
ADuC7021 thermal performance
ADuC702x - can I use the PLA when the Microcontroller is in boot mode?
ADuC7060 Product life cycle
ADuC7061 self-offset calibration
ADuC7061: Connecting 32Khz External Crystal
ADuC70xy USB Combi-Downloader
ADuC7xxx: Issues when debugging with JTAG interface
ADuC7xxx: Can I read flash/eeprom and reprogram specific addresses via UART?
ADuC: What are the options for freeware development tools/IDE?
Analog Current Output with in the pA or fA range
ARM7 Core Products Space Description
Connection of Exposed paddle (E-pad) on ADuC702x
Difference between ADUC7060 and ADUC7061?
Download Hex to flash - Find bootloader files
FAQ: How many PWM outputs can be configured on the ADuC7020?
How-To port FreeRTOS to ADuC7x26
I2C example code
I2C Module on ADuC70xx
IAR licence for QuickStart PLUS kits for ADuC702x-series Microcontrollers
Lost License info of existing MIDAS Programming Adapter for ADUC7026
Max baudrate on ADuC7060
Programming Specification for ADuC7033
SPI Communication Issue
Unable to read ADC of ADuC7060
USB-I2C download hex file issue
Download to the eval board is ok, trouble is with my board. Pulling down P0.0
and power-cycling does not enter the programming mode but starts
(preprogrammed) application. Reserved vector is 0x00000000 in this case.
Writing 0xFFFFFFFF to the reserved vector 0x80014 enters (I2C?) programming
mode but does not honor the RS-232 ping. RS-232 connection is o.k and used in
the application. Is there an other condition that must be considered to get the
serial download running?
1) To enter Serial download mode, the external Reset pin must be toggled
when P0.0 his held low. Power cycling with P0.0 low will not force the part
into Serial download mode. It's the falling edge of the external reset with
P0.0 low that places the part into download mode.
2) The I2C download protocol that you mention is not relevant with our
evaluation boards. Our parts are shipped with one of two Kernels. The standard
Kernel that is programmed on all our evaluation board parts is the Serial
download based kernel. The only sequence this part needs to enter download mode
are the steps mentioned in point 1.
Privacy & Security Statement
Accept & Continue