ADCMP602 output "weakly" pulled up in shutdown mode

Question

Accepted Answer

Q 
 The datasheet doesn't mention the status of the output pin in case the shutdown 
 
 SDN input has been activated. What's the expected behaviour in this case? I 
 
 suspect the output pin enters tri state mode. Is this correct? 
 
 A 
 The ADCMP602 shutdown mode is to save power achieved by reducing many of the 
 
 internal bias currents. 
 
 It does not put the part in a tri-state condition. As such, the ADCMP602 
 
 outputs will be “weakly” pulled up.