Package

Hi,

Thank you for your question. I am reviewing the information you provided and may come back with follow up questions. I appreciate your patience as I work on your query. 

Regards,
Gilbeys

Hi Andromeda8 ,

Connecting the exposed pad to ground is not always the case, it depends on the part. Normally not electrically isolated, it typically needs to be connected to a ground or power plane, depending on the device. I would always recommend following the datasheet. For the LT6226, the EPAD must be connected to ground for single supply, and V- for dual supply configuration.

Here are some links that may help you with your question:

https://www.analog.com/en/resources/analog-dialogue/articles/high-speed-printed-circuit-board-layout.html

https://www.analog.com/en/resources/design-notes/exposed-pads-a-brief-introduction.html

Thanks,

Gio

Hi Andromeda8 ,

Connecting the exposed pad to ground is not always the case, it depends on the part. Normally not electrically isolated, it typically needs to be connected to a ground or power plane, depending on the device. I would always recommend following the datasheet. For the LT6226, the EPAD must be connected to ground for single supply, and V- for dual supply configuration.

Here are some links that may help you with your question:

https://www.analog.com/en/resources/analog-dialogue/articles/high-speed-printed-circuit-board-layout.html

https://www.analog.com/en/resources/design-notes/exposed-pads-a-brief-introduction.html

Thanks,

Gio