AD8510 and capacitive loads

I use the AD8510 in unity gain configuration as DAC buffer. The resistive load at the output is 10kOhm and there is also a capacitive load due to cable capacitance in the range of 1 - 2nF. Which compensation method for the capacitive load would you recommend? To preserve DC accuracy I won't use a output series resister larger than 5Ohms. The compensation method should preserve DC accuracy and it should be able to cope with 1nF

as well as 2nF capacitive load.

I have an additional question about snubber networks to compensate for capacitive loads: is the order of the capacitor/resistor series connection relevant? Does it have to be op amp output --> resistor --> capacitor --> ground, or is op amp out --> resistor --> capacitor --> ground also ok?

Regards,

Steffen

Parents
  • 0
    •  Analog Employees 
    on Aug 2, 2018 4:50 PM
    This question has been assumed as answered either offline via email or with a multi-part answer. This question has now been closed out. If you have an inquiry related to this topic please post a new question in the applicable product forum.

    Thank you,
    EZ Admin
Reply
  • 0
    •  Analog Employees 
    on Aug 2, 2018 4:50 PM
    This question has been assumed as answered either offline via email or with a multi-part answer. This question has now been closed out. If you have an inquiry related to this topic please post a new question in the applicable product forum.

    Thank you,
    EZ Admin
Children
No Data