Hello,
I'm designing AD8000&AD8001 for testing purpose. The AD8000's datasheet says:"Do not use ground and power planes under any of the pins of the AD8000." Is this means that I have avoid copper of the ground (or power) plane adjacent top layer?
Below is my baord's layers structure:(Do i have to remove some copper of the Agnd1 just under the AD8000&AD8001?)
And here is the AD8001 and AD8000 used in my new test board:
Anybody can show me an example of this?
Hi Jay,
Thanks for you reply.
My 50 ohm trace width is not same as the pin width, so i have to remove the GND under pin. I took the removing action as below for my new test board. Which one is better? Though the left is AD8001, and the right one is AD8000.
I just took over the AGND1, and didn't remove the GND of AGND2 and DGND.
Best Regard
Hi Jay,
Thanks for you reply.
My 50 ohm trace width is not same as the pin width, so i have to remove the GND under pin. I took the removing action as below for my new test board. Which one is better? Though the left is AD8001, and the right one is AD8000.
I just took over the AGND1, and didn't remove the GND of AGND2 and DGND.
Best Regard
