AD586 Trimming

The AD586 (5V reference) has a trim pin on it.  I would like to use that trim pin to crank the reference output up to 5.12V.  Unfortunately, there is no equation to help me select the proper resistors needed to do this.  Figure1 of the datasheet shows resistors, but doesn't give values.  Are these resistor values known, or are they trimmed at the time of manufacturing?  If they are known, I could use those to come up with my own equation.

Is it possible to get either the equation or the resistor values?  If necessary, approximating will do fine, just need an initial guess for the trim resistors.

Thanks!

Parents
  • 0
    •  Analog Employees 
    on Aug 2, 2018 4:29 PM
    This question has been assumed as answered either offline via email or with a multi-part answer. This question has now been closed out. If you have an inquiry related to this topic please post a new question in the applicable product forum.

    Thank you,
    EZ Admin
Reply
  • 0
    •  Analog Employees 
    on Aug 2, 2018 4:29 PM
    This question has been assumed as answered either offline via email or with a multi-part answer. This question has now been closed out. If you have an inquiry related to this topic please post a new question in the applicable product forum.

    Thank you,
    EZ Admin
Children
No Data