I have a couple of question for your AD8260.
I will just use only the high current driver part.
Not use VGA/PreAMP and VMID buffer parts.
If so, how should I connect the NOT USING PIN, GND or OPEN or Pull-up high level?
And please give me the good comment for such way? Can I use only high current driver part?
Can I use by 5V single ended power supply for the high currnet part?
If so yes, what is the output current? How should think it?
On your data sheet. I can see RLOAD = 1 Ω, VIN = ±0.5 V +/-310mA only ,I cannot find the case of single end input.
Our application is radio device.
AD8260 get the diff-signal 1Vp-p from AD9762 DAC and take the signal to next LPF for transmit by antenna.
AD9762 get the 3MHz FSK signal from front device. So I use the signal 1MHz to 4MHz on AD8260.
If you have an another good device for this case, please recommend it to me?
I need around 0.3W the outout power from driver.
Apologies for the late reply. If you are only going to use the high current driver, you could check out AD8390, AD8397, AD8016 or AD8018 instead. Will these fit your application? Let me know if you have more questions.