This is my design circuit about ADA4350.
Who can help me to check it ？
The Power VSS=10V, VDD=5V.
Single end signal input.
Upon first check - did you intend to use R18 and R17 as gain-setting resistors for amplifier P1? If so, then R17 should be connected to the RF1 pin instead of at VOUT1.
What will the resistor and capacitor network at the inverting input of the FET amp be used for? Are you adding a provision to try and simulate the photodiode?
Also, since you are operating in a single-supply configuration, you may want to add a provision for biasing the non-inverting input up by a small value (usually just so the output of the FET amp does not saturate). You can check the evaluation board of the ADA4350 as a reference.
May I ask what your photodiode is and for what application, in case I can offer additional recommendations?