My customer uses AD8015.
There is a one point question so please tell me.
The contents of the question are as follows.
About the case of using Figure 17 of the data sheet of AD8015.
At this time, it is about the case where the input to clip more than ± 30uA is applied..
Is it OK to recognize that the differential output of the 6th and 7th pins of the AD8015 maintains the relationship of inversion?
Is the center voltage with amplitude different at pins 6 and 7?
I do not think so, but please tell me because there is no spicedate.
Hi baggio: The 30uA spec is for linearity (2.5% distortion). The AD8015 doesn't fully clip until about 350uA. The circuit can't clip for a long time, because the input is AC coupled. But the output CR dictates that the output voltages will tend towards V1. Does this answer your question?
Thank you for answeringIt seems that I was wrong in the way of thinking.
It was saved. Thank you very much.