Dear Support,
Error occurred "Analysis time step too small; time = 1.7562e-005, timestep = 1.25e-019; trouble with U5:swlim-instance s:u5:4" while doing transient analysis with LT1994 .Please guide me to sort out this issue.
Figure1: Time step too small error:
Figure2:
Regards
Bala
Hi Balakrishnan K,
I tried to replicate the error you're getting with the LT1994 but I can successfully run the similar circuit on transient analysis.
Here's the result: Vo+ - Vo- = 1V;
Vin+ = 3V and Vin- = 2V.
I think the model itself is working in terms of functionality.
May I see the rest of your schematic to see if something else is causing the error? Also what's your transient analysis configuration?
I only set my stop time to 5ms in this simulation.
Thanks Balakrishnan K.
Best Regards,
Dann
