VCOM on ADL5562

Guillaume.Blan over 9 years ago

Hello,

I have designed a board with 16 ADL5562. I need to set the VCOM of all these diff.amp. at 1V. So I used a single LP3879-1.0 (http://www.ti.com/lit/ds/symlink/lp3879.pdf) to directly feed all the ADL5562 VCOMs. But unfortunately the voltage delivered by this regulator is unable to overide the internal VCOM (VCC/2=1.65V).

Any suggestions ?

Cordially,

Guillaume.

Parents

0 EZAdministrator over 3 years ago

This question has been assumed as answered either offline via email or with a multi-part answer. This question has now been closed out. If you have an inquiry related to this topic please post a new question in the applicable product forum.

Thank you,
EZ Admin
Cancel
Up 0 Down

Reply

Reject Answer

Cancel

Reply

0 EZAdministrator over 3 years ago

This question has been assumed as answered either offline via email or with a multi-part answer. This question has now been closed out. If you have an inquiry related to this topic please post a new question in the applicable product forum.

Thank you,
EZ Admin
Cancel
Up 0 Down

Reply

Reject Answer

Cancel

Children

No Data