Hi,
I have a ADA4433-1CP-EBZ Evaluation Board. I have connected the board to a video source and I am evaluating the differential output of the Evaluation Board.
The ADA4433-1CP-EBZ is setup as factory default, with +IN connected to the video source, and -IN connected via a resistor divider to generate 0.5V offset. I have connected the differential output to an AD ADA4830-1 (Differential to single ended).
My questions / Concerns are:
1. When I connect the video signal to the +IN of the ADA4433 the video signal goes from 1V P-P to +/-0.5V P-P. Is this correct?
2. The differential output does not represent the negative side of the input signal, only the positive side. Have I missed something?, can anyone please help advise what I am doing wrong?.
Attached below is the screen shot from the CRO. The differential signal only represents the positive side of the input signal (+0.5v Peak)
Thanks.
Lok.
