Qestions about AD8138

Question

Hi there, I have some questions about AD8138. 
 #1, Is there any problem if this device is used with V+=7V, V-=-3V? 
 I checked the simulation tool and I think it looks fine. 
 #2, If the V supply condition is a bit different from the datasheet specification table, 
 Can I consider the spec of the input voltage range and output voltage swing is the same? 
 #3,I can't find the open loop spec and open loop phase graph. Could you share the data and graph to consider the gain setting and stability? 
 Best regards, 
 Tarzan

JinoL · Accepted Answer

Hi Tarzan, 
 Apologies for this late response. 
 As for your questions: 
 1. Using unbalanced supplies is okay as long as the difference between Vcc and Vee is within the specified range of the amplifier. So +7 V and -3 V is fine. 
 2. No. The ICMVR will change significantly. There has no specific data on that supplies but base on the specs table, it is safe to operate the ICMVR within -2.7 V to + 5.4 V. 
 3. You could refer to Figure 10 of the datasheet for gain setting and responses. 
 Regards, 
 Jino)

Electronic Design Services - PartnerZone

Products In This Thread

Qestions about AD8138

Thread Notes