• State Not Answered
  • Replies 2 replies
  • Subscribers 26 subscribers
  • Views 482 views
  • Users 0 members are here
Options
Related 

        

            Post
             Go back to editing
        

    

    


    

    









		











	
	
			
	
			
		
	
	
		

		
OP467



		

			

									Anonymous
							

			
				
									Anonymous
											
							 		
		        	            							
			
			    	
			                    
                
				                on Apr 17, 2019 
				
			
			
		


				
		

		    		    
		    
		    	
			
Hello,


I am trying to build an amplifier for quite a wide range of frequencies (40Hz -  200 kHz).  I wanted to use OP467 since it has quite a wide bandwidth. So, using one section of OP467, I built an inverting amplifier with a gain of 10. However, I am starting to observe a decline in gain at about 40 kHz.  At 100 kHz, the attenuation of gain is about 60%.  Is there anything that I am missing or these results are reasonable?


Thanks,


Anton.

								


				
				
		

			
						
									
									
						
						
			
			
			
			
		


					

			





	

		
	















	

	

					



			


				
	









	
    
	

  • 
	
    



	
		
	
	



    
	
    
		
    
							
					
    
		
    
			
													0
							
			
				
									
							        
            
                                                                                                        
      
                            
    • 
                                 Analog Employees 
                                
                            
      • 
                        
     
                                                           			
			                            
                        
                on Apr 28, 2019 2:12 PM
            
            
					
    
	
    

		
		
    
					
    Hi Anton,
    

    Looking at the OP467's TPC in the datasheet, you should not have any problem with the gain at 100kHz signal.
    Though you mentioned that you're only using one section of OP467, did you configure the unused amplifiers to unity-gain follower with the non-inverting pin connected to ground (I'm assuming your amplifier is configured in dual supply scheme)? These unused amplifiers may cause cross-talk to the one you're using. 
    If you've done this, please provide your schematic diagram so that we'll be able to help you further.
    

    Thanks.
    

    Best Regards,
    Dann
    
			
    

		
		
		
		
	
    
	
    
		
    
			
		
    
	
    
	
    
		
						
						
				
						
				
				
		
		
    
			
		
    
	
    

    

    • 

	

  • 
	
    



	
		
	
	



    
	
    
		
    
							
					
    
		
    
			
													0
							
			
				
									
							        
            
                                    			
			                            
                        
                on Apr 28, 2019 10:02 PM
            
            
					
    
	
    

		
		
    
					
    What package?
    

    pcb? or breadboard strip?
    

    Load on output?
    

    Size of resistors?
    

    Schematic?
    

    Harry
    
			
    

		
		
		
		
	
    
	
    
		
    
			
		
    
	
    
	
    
		
						
						
				
						
				
				
		
		
    
			
		
    
	
    

    

    •