I am currently working on a capstone design project and need to utilize the evaluation module for an analog filter I designed using the Filter Wizard.
One challenge I am facing is that I cannot seem to locate where to place the J5M and J6M parts on the motherboard (picture attached below) from the evaluation module (EVAL-FW-MOTHER).
What is confusing is that when I try to order the parts, the website lists parts J5M and J6M as part of the package (shown in picture below). Can someone help me understand why these parts are included in the kit but are not located on the assembly pdf figure (have noticed this for the multiple stages of my filter as well)?
Thank you for your time!
Thanks for uploading the picture. That was helpful. J5M and J6M are the SMA jacks at the edge of the board. Depending on your connectivity needs, you can also access the same signals using the IN_TP and OUT_TP test pins (note that these two test pins are not normally listed in the BOM.)
Thank you so much! Makes sense!