Post Go back to editing

Custom Pluto

Category: Hardware
Product Number: PLUT

Hi everyone,

I am a beginner, I made a custom pluto board.

After programing firmware ( pluto.dfu) via DFU mode and programming bitstream (system_top.bit), my custom Pluto board works correctly. The PC can identify Pluto, and the Pluto board can communicate with the Matlab.

However, if I disconnect the power and then connect the power again, it does not work even though the PC cannot detect the USB port, however, if I program Bitstream again, the firmware works, and the Pluto board works

Thank you so much

Parents Reply Children
No Data