Post Go back to editing

ADALM-PLUTO [NETWORK] vs [USB_ETHERNET]

Category: Software
Product Number: ADALM2000 m2k
Software Version: Firmware v0.31

Hello everyone,

I have an ADALM-PLUTO board connected to my network via an Ethernet dongle. To do so, I've modified the  ipaddr_eth on the [USB_ETHERNET] category as many tutorials say.

My question is about the [NETWORK] 'category' and its usage. I've not found many documentation in this regard, and I'm interested to know if it would be possible to use it in parallel, like TX streaming of data over [NETWORK] and patches, control, etc. via [USB_ETHERNET]. Is that even possible? If it is, how or where should I start looking?

Thanks in advance,

Best.



misspelling correction.
[edited by: zoqueton99 at 2:30 PM (GMT -4) on 10 May 2023]