I want to use ADALM-PLUTO for getting GHz frequency at the SMA TX output .
I am not finding any such tutorials.
can anyone suggest please.
I want to use ADALM-PLUTO for getting GHz frequency at the SMA TX output .
I am not finding any such tutorials.
can anyone suggest please.
We recommend using Pluto in a development framework like MATLAB or GNU Radio.
MATLAB: https://www.mathworks.com/hardware-support/adalm-pluto-radio.html
GNU Radio: https://wiki.analog.com/resources/tools-software/linux-software/gnuradio
Here is also some general intro material on Pluto (See bottom Slides and Labs): https://wiki.analog.com/grcon2018
-Travis
hi
really speaking I am not finding those materials very supportive.
I am new to this.
can you please briefly explain how to get high frequency output at SMA out(tx) using a single ADALM pluto.
thanks
-sudersan
Please start reading here:
https://wiki.analog.com/university/tools/pluto
you can use OSC with the fmcomms2 plugin:
https://wiki.analog.com/resources/tools-software/linux-software/iio_oscilloscope
https://wiki.analog.com/resources/tools-software/linux-software/fmcomms2_plugin
Simply set TX LO to the desired frequency and use FPGA settings DDS: One CW Tone.
-Michael
thank you . I will try
-sudersan
I went through the documents.
Not yet clear.
I am not finding a proper example to get GHz RF output at the SMA connector where the frequency can be controlled through MATALB/SIMULNK.
Hello,
Please see this example of Spectral Analysis with ADALM-PLUTO and Matlab: https://www.mathworks.com/examples/communications/mw/plutoradio_product-plutoradioSpectralAnalysisExample-spectral-analysis-with-adalm-pluto-radio
Just open the 'ADALM-PLUTO' Receiver block (double-click) to configure the frequency parameter.
Other examples can be found here:
https://www.mathworks.com/examples/communications/category/plutoradio
Regards,
hi
thanks you .I will try.
regards
sudersan
hi
I tried with your suggestion from www.mathworks.com/.../plutoradio_product-plutoradioSpectralAnalysisExample-spectral-analysis-with-adalm-pluto-radio
I am able to get the waveform displayed.
but I don't see any signal at the SMA output(TX) of pluto.
how can I get the frequency output at the SMA connector?
regards
sudersan
Hello,
In the second link that I sent, you can find examples that contain the Pluto Transmitter block:
By clicking the "Open the companion plutoradiofreqcalib Tx model" link you can get to an example of generating a sine wave
The output data can be seen using the receiver block example via loopback connection.
Please let me know if you need further assistance.
Regards
hi
thank you . I will try and let you know.
regards
sudersan