How to simultaneously transmit TDM and PDM data to the A2B bus at a slave node

Question

According to the AD2428 TRM, nodes can enable both TDM and PDM simultaneously. 
 If RX0 is used for TDM, RX1 is used for PDM. In this case, how is the order of audio data received by TDM and PDM on the bus slot determined？ 
 I didn't see any method on the sigmastudio tool that can correspond stream to audio channel.

arunk · Accepted Answer

Hi yywang 
 Once the pin configuration is done, then you can Right Click on Target Processor -> Stream Config. There under Audio stream definition you can define the data slots and Audio Stream Assignment from one node to another can be done using the ' Audio Stream Assignment ' tab. Then the audio slots will be routed accordingly inside the respective nodes.)

Partner Forums

Partner Libraries

Products Mentioned

How to simultaneously transmit TDM and PDM data to the A2B bus at a slave node